MC1R is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2026-06-19. Numbers and descriptions here follow the published literature rather than marketing material.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Melanocortin receptors comprise five subtypes with distinct tissue distributions and functions. Melanotan-2 is described in the literature as a non-selective agonist that engages several of these subtypes, including MC1R, MC3R, MC4R, and MC5R. MC1R is the subtype most directly linked to melanin production in skin cells. Because the compound is not subtype-selective, its observed effects in experimental settings are generally attributed to activity across multiple receptor pathways rather than to a single target.
Melanotan-2 is a synthetic linear peptide built from seven amino acids arranged in a short chain. Its sequence is commonly written as Ac-Nle-Asp-His-D-Phe-Arg-Trp-Lys-NH2, which includes a modified N-terminus and an amidated C-terminus. The molecule belongs to the melanocortin family and acts as a receptor agonist. Structural features such as the D-phenylalanine residue and the Nle substitution are associated with increased stability against enzymatic degradation relative to the natural parent peptide.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material may be hygroscopic |
| Solubility class | Soluble in water, DMSO and DMF | Dilution into aqueous buffer can cause precipitation |
| Storage of solid | Minus 20 degrees C, desiccated, dark | Aliquot to limit repeated opening of the vial |
| Storage of solution | Minus 20 to minus 80 degrees C, aliquoted | Avoid repeated freeze-thaw cycles |
| Identity method | Reversed-phase HPLC with mass spectrometry | Retention time and mass are checked together |
The material is commonly handled as a lyophilized powder in sealed vials. The solid dissolves readily in water and in polar organic solvents, producing a clear solution after reconstitution. Light, heat and repeated freeze-thaw cycles are the concerns most often raised in handling guidance, because peptide bonds and the constrained ring can degrade. Working solutions are generally prepared fresh, and material left in solution is treated as less stable than the dry form. These properties shape how laboratories store and aliquot reference material.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography with ultraviolet detection, often paired with mass spectrometry. Retention time supports identity, while the mass spectrum confirms the molecular weight of the intact peptide. Purity is frequently reported as a percentage of total peak area, a figure that depends on the wavelength, column and gradient used. Impurity profiling may also look for truncated sequences, oxidised forms and residual counterions. Amino acid analysis and peptide mapping provide orthogonal confirmation when required.
Regulatory status varies by jurisdiction, and the substance is frequently described as unapproved for therapeutic use. Some authorities classify it alongside prescription-only medicines or controlled categories, while others address it through general consumer protection rules. Analytical surveys have reported mismatches between label claims and measured content in products sold online, although the scope of such testing is limited. Whether these discrepancies are widespread remains an open question. Discussion in the literature therefore tends to combine chemistry, supply-chain observation and policy analysis.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
== Research == Luvesilocin is under development for the treatment of postpartum depression (PPD), treatment-resistant depression, and other psychiatric disorders. As of September 2025, it has reached phase 2 clinical trials for these indications. A phase 3 trial is planned for 2026. The drug is being developed by Reunion Neuroscience (formerly known as Field Trip Health).
After labeling of the surface with the selected F bioactives, the constructs will be present and oriented at the membrane surface. It is expected that the FSL will be highly mobile within the membrane and the choice of lipid tail will effect is relative partitioning within the membrane. The construct unless it has flip-flop behavior is expected to remain surface presented. However, the modification is not permanent in living cells and constructs will be lost (consumed) at a rate proportional to the activity at the membrane and division rate of the cell (with dead cells remaining highly labeled). Additionally, when present in vivo with serum lipids FSLs will elute from the membrane into the plasma at a rate of about 1% per hour. In fixed cells or inactive cells (e.g. red cells) stored in serum free media the constructs are retained normally. Liposomes are easy koded by simply adding FSL Kode constructs into the preparation. Contacting koded liposomes with microplates or other surfaces can cause the labeling of the microplate surface.
Before and during World War II, the primary role of the submarine was anti-surface ship warfare. Submarines would attack either on the surface using deck guns, or submerged using torpedoes. They were particularly effective in sinking Allied transatlantic shipping in both World Wars, and in disrupting Japanese supply routes and naval operations in the Pacific in World War II. Mine-laying submarines were developed in the early part of the 20th century. The facility was used in both World Wars. Submarines were also used for inserting and removing covert agents and military forces in special operations, for intelligence gathering, and to rescue aircrew during air attacks on islands, where the airmen would be told of safe places to crash-land so the submarines could rescue them. Submarines could carry cargo through hostile waters or act as supply vessels for other submarines. Submarines could usually locate and attack other submarines only on the surface, although HMS Venturer managed to sink U-864 with a four torpedo spread while both were submerged. The British developed a specialized anti-submarine submarine in WWI, the R class. After WWII, with the development of the homing torpedo, better sonar systems, and nuclear propulsion, submarines also became able to hunt each other effectively. The development of submarine-launched ballistic missile and submarine-launched cruise missiles gave submarines a substantial and long-ranged ability to attack both land and sea targets with a variety of weapons ranging from cluster bombs to nuclear weapons.
Vaginal films are soluble, thin sheets of medication that are inserted into the vagina where they dissolve and release the substances. Typical uses include delivery of contraceptive substances or antibiotics for infections. These films are inserted by simply pushing them into the vagina with one’s fingers. There they dissolve quickly upon interaction with natural vaginal fluids. Bioadhesives are substances that naturally stick to live tissue. Currently, studies are being done on bioadhesives adhering to cervical mucous membranes to allow for an extended release period. The drug would be released with mucus to create a localized treatment with high effectiveness. This is anticipated to be highly useful for treatment of cervical cancer. Bioadhesives can come in multiple forms, such as films, tablets, or gels. The appeal of bioadhesives is that they take advantage of the mucous environment surrounding the cervix and utilize it to benefit the drug delivery mechanism.
Sources: en.wikipedia.org
Computing the total disintegration energy given by the equation Edi = (mi - mf - mp)c2 where mi is the initial mass of the nucleus, mf is the mass of the nucleus after particle emission, and mp is the mass of the emitted (alpha-)particle, one finds that in certain cases it is positive and so alpha particle emission is possible, whereas other decay modes would require energy to be added. For example, performing the calculation for uranium-232 shows that alpha particle emission releases 5.4 MeV of energy, while a single proton emission would require 6.1 MeV. Most of the disintegration energy becomes the kinetic energy of the alpha particle, although to fulfill conservation of momentum, part of the energy goes to the recoil of the nucleus itself (see atomic recoil). However, since the mass numbers of most alpha-emitting radioisotopes exceed 210, far greater than the mass number of the alpha particle (4), the fraction of the energy going to the recoil of the nucleus is generally quite small, less than 2%. Nevertheless, the recoil energy (on the scale of keV) is still much larger than the strength of chemical bonds (on the scale of eV), so the daughter nuclide will break away from the chemical environment the parent was in. The energies and ratios of the alpha particles can be used to identify the radioactive parent via alpha spectrometry. These disintegration energies, however, are substantially smaller than the repulsive potential barrier created by the interplay between the strong nuclear and the electromagnetic force, which prevents the alpha particle from escaping.
=== Clostridioides difficile infection === S. boulardii has been associated with a reduction in recurrence rates among patients with recurrent Clostridioides difficile infection and may be effective as a secondary preventive intervention. Evidence does not support its use as a primary treatment for acute infection.
== Causes == The pathophysiology of polymyalgia rheumatica is not well-understood. Evidence shows that there is likely a combined genetic and environmental pathophysiology behind the disease, but concrete identification of the causes, including whether or not polymyalgia rheumatica is an autoimmune disease, remains elusive. It is, at the very least, an immune-mediated disease, with both innate and adaptive immune system elements being known to play a role. Infectious diseases have historically been hypothesized as a likely trigger for disease in genetically susceptible people. Individual studies have sometimes found correlations between specific pathogens and development of the disease, but broader analysis fails to find significant correlations. Proposed causative pathogens, none of which have been proven, include:
Sources: en.wikipedia.org
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.
Peptides are commonly isolated as acetate or trifluoroacetate salts, and the counterion contributes to total mass. Two vials with identical peptide content can therefore differ in weight and in measured response. Residual trifluoroacetate is also relevant in cell-based work because it can influence membrane behaviour.
Degradation products are often closely related to the parent molecule, making them hard to resolve with a single method. Counterion variability adds a further source of scatter between laboratories. Because no pharmacopoeial monograph exists for melanotan-2, groups rely on method-specific validation rather than a shared reference standard.
No. Melanotan-2 is manufactured synthetically. The naturally occurring peptide in the same family is alpha-melanocyte-stimulating hormone, which the body produces as part of normal endocrine and neural signalling.